Pool Leak Detection Pros provides fibreglass pool lining in Kirkney using a systematic testing process rather than guesswork.
We apply a continuous bonded fibreglass lining over a properly prepared shell, so a porous or repeatedly-leaking pool gets one watertight surface instead of endless patching.
Our approach is deliberately non-destructive. We test before we touch anything: suction and return lines are pressure tested, fittings and cracks are dye tested, and underground runs are checked with tracer gas. Only once the leak is confirmed do we recommend opening anything, and only at the exact spot the evidence points to.
Most homeowners in Kirkney discover a leak the slow way: topping up more often, fighting algae caused by dilution, or noticing the water bill creeping up. The sooner the source is confirmed, the less water and money drains away before it is fixed.
The water level, pump behaviour and the level at which a pool stops dropping are all clues. We read those alongside controlled pressure and dye testing to separate a plumbing leak from a structural or surface leak, because the repair for each is completely different.
Not all water loss is a leak. A small daily drop in hot or windy weather can be ordinary evaporation. The difference is consistency: a leak keeps losing water even in cool, still conditions, and often drops to a particular level and then slows. Testing is the reliable way to tell the two apart.
It may be worth booking a test if you are seeing any of these in Kirkney:
Detection and repair are quoted separately and honestly. We confirm the cause first, then scope the repair to match, so you are never paying for hidden work that was priced before anyone knew what was wrong.
The quickest way to get a useful answer is to send your address, a description of the symptoms and a few photos of the pool and pump area on WhatsApp. We can then advise on the likely cause and the right test for your pool in Kirkney.
The correct repair depends on whether water loss is coming from the pool shell, suction line, return line, light niche, weir, aimflow jet, equipment station or deteriorated finish.
Repairing a pool without confirming the leak source can waste money. A leaking return line will not be solved by resurfacing, and a porous pool shell will not be solved by replacing one pipe. We narrow the cause before recommending repair.
We begin with a visual inspection and symptom review. Where plumbing is suspected, suction and return lines are isolated and pressure tested. Where structural or fitting leaks are suspected, dye testing is used around the relevant areas. Tracer gas may be used for underground leaks where the pipe route and conditions allow accurate location.
The outcome is a practical recommendation: localised repair, pipe replacement, fitting repair, crack repair, fibreglass lining, re-marblelite or full renovation depending on what the evidence shows.
A pool leak is likely when water loss is faster than normal evaporation, especially if the level drops overnight, the pump loses prime, bubbles return through the aimflows or wet ground appears around the pool.
A visible fitting leak can sometimes be quoted from photos, but hidden underground or structural leaks should be tested first. Guessing often leads to repairing the wrong area.
No. Many leaks are found at lights, aimflow jets, weirs, cracks or deteriorated pool finishes. Digging should only happen after the leak position has been narrowed down.
Yes. Old, porous, cracked or hollow marblelite can allow water loss through multiple small openings, especially when the finish has reached the end of its service life.
Yes. Pinholes, delamination, poorly sealed fittings and cracks can cause fibreglass pools to lose water.
The investigation may include visual inspection, pressure testing, dye testing, tracer gas and process-of-elimination checks depending on the symptoms.
Yes. Leaks that worsen when the pump is running often involve return lines, pressure-side plumbing, aimflow jets or equipment connections.
Yes. Leaks while the pump is off often point to the shell, light niche, weir, fittings, cracks or static plumbing leaks below water level.
Yes. Findings can be provided with a technical summary and repair recommendations for homeowners, body corporates or insurance purposes.
Once the leak source is identified, the repair is quoted separately with a recommended scope based on the confirmed cause of water loss.
Please complete the details below so we can qualify the leak properly before dispatching a technician. The inspection fee covers leak detection and diagnosis only. Repairs are quoted separately after testing.